Aida Sound Users Forum

Hello,

I was making good use of the sends volume controls section of DTouch for Cubase. (Where you could select send 3 for example and then control the send 3 volumes using each channel's fader.)

Is this section still available? I do not see it in the new 1.2.0 version of DTouch.

Thanks.

look at the "VOL" button, but if you want you can paste the DTouh "factory" command where you want.... look at the manual...

rcprod wrote:Hello,

I was making good use of the sends volume controls section of DTouch for Cubase. (Where you could select send 3 for example and then control the send 3 volumes using each channel's fader.)

Is this section still available? I do not see it in the new 1.2.0 version of DTouch.

Thanks.

Check Page 64 of the User Guide (DTouch for Cubase V1.2.0 Revision 1): "Fader Control Mode Toolbar Panel"

I did look over the manual quickly to check out new features/changes.....not a lot of spare time so did not go into it in detail.

Thanks, I will check out the page in the manual that you have pointed out. Cheers.