Superior Drummer 3 tracks unnamed in DT Mix

[DT_bettinzana]

Any progress on the ticket that I opened for missing track names?

Hello!
We were unable to replicate that issue with other multi-output Virtual Instruments.
Now I have access to a machine with SD3 and I could try to replicate that scenario.
Unfortunately I am not an expert of SD3; can you send to support@deviltechnologies.com some instructions to setup SD3 and Cubase according to your current faulty Cubase project?

Thank you.

[DT_bettinzana]

I have created a Cubase Project with Superior Drummer 3 and I have activated 16 Stereo Output in SD3 VSTi.
I see the correct name of the outputs in the Cubase mixer and I see the same exact names in the DTouch Floating Mixer.

That said, you should also send some screenshots to support@deviltechnologies.com

The only "special condition" is that we have Cubase 8.5 on the machine used for this test.

Thank you.

[TonyR]

Sure, I can send those... You should try it on Cubase 10 though, since that is where I said the problem lies.

[DT_bettinzana]

You should try it on Cubase 10 though, since that is where I said the problem lies.

Of couse, but at the moment I cannot do it.
Lets start to understand if we are speaking about the same thing.

[TonyR]

I could not test in 8.5, but try this in Cubase 9.5 or higher.

Load SD3 into a project. In Cubase set SD3 to multiple outputs. Open DT floating mixer. The multiple output names are displayed corrected. But note that both the parent track and the first output lanes have the same name... Now save that project and close DT. Reopen the project and the DT floating mixer...those names are now missing. I think the behavior is occurring because the parent track and the first output track have the same names. Same names is an issue with DT. I am trying to find a Cubase or SD3 solution so the parent track and the first output lane can be named differently...no luck so far.

Anyone else having this?

[DT_bettinzana]

I could not test in 8.5, but try this in Cubase 9.5 or higher.

Load SD3 into a project. In Cubase set SD3 to multiple outputs. Open DT floating mixer. The multiple output names are displayed corrected. But note that both the parent track and the first output lanes have the same name... Now save that project and close DT. Reopen the project and the DT floating mixer...those names are now missing. I think the behavior is occurring because the parent track and the first output track have the same names. Same names is an issue with DT. I am trying to find a Cubase or SD3 solution so the parent track and the first output lane can be named differently...no luck so far.

Anyone else having this?

OK, now it's more clear. I will try tomorrow.

Thanks

[TonyR]

Did you try?

[DT_bettinzana]

Did you try?

Yes, but I don't see that problem.
But, honestly, I don't understand your "parent track" and "first output track".
Please, post some screenshots.

Thank you.

[TonyR]

I will send them via open ticket email that I have with you.

[DT_bettinzana]

I will send them via open ticket email that I have with you.

OK, thank you.