Page 1 of 1
Fader for Cue Level
Posted: 13 Jan 2020 17:06
by petermcc
Anyone know a way of creating a DTouch fader to control cue level in control room. The Cubase one is hard to operate with touch and is far too small.
Re: Fader for Cue Level
Posted: 14 Jan 2020 12:08
by Support Team
There's no way to create a Fader in DTouch to control a Control Room Cue Level.
However, the DTouch Control Room Window has one Pad for each Cue, allowing you to control such levels. You can find them in the optional "Cues" section.
This is all described in the DTouch User Guide, at Chapter 4.2.10, including how to enable the "Cues" section.
Re: Fader for Cue Level
Posted: 14 Jan 2020 16:54
by petermcc
Thanks that's what I thought. Admittedly the cue level touch pad in DTouch control room is far better suited to touch than the Cubase fader but visually not as one would like.
Re: Fader for Cue Level
Posted: 15 Jan 2020 19:16
by DT_bettinzana
petermcc wrote: ↑14 Jan 2020 16:54
Thanks that's what I thought. Admittedly the cue level touch pad in DTouch control room is far better suited to touch than the Cubase fader but visually not as one would like.
OK, but a large fader would take a lot of space.
Re: Fader for Cue Level
Posted: 16 Jan 2020 06:46
by petermcc
How about if it were incorporated into the Cue sends mixer much as the Main out fader is. I find when using the cue mixer I miss the ability to control the overall output.
When using the main mixer I always have an overall output control through the main out fader.
Re: Fader for Cue Level
Posted: 16 Jan 2020 19:00
by DT_bettinzana
petermcc wrote: ↑16 Jan 2020 06:46
How about if it were incorporated into the Cue sends mixer much as the Main out fader is. I find when using the cue mixer I miss the ability to control the overall output.
When using the main mixer I always have an overall output control through the main out fader.
This is definitely a good idea, possible but not easy to be implemented. I don't think that we will do it in the near future.