My dtouch setup
Posted: 04 Jul 2020 08:55
Sorry for the delay. Excuse, excuse, excuse.
Attached is a shot of my DTouch setup.
Ones I use all the time are :-
Roll & Record. This switches in metronome, activates punch in and punch out, activates pre roll, turns off cycle and immediately starts rolling. That's six buttons into one.
Bounce. use all the time, really quick once you are used to its position.
Show track volume. Opens and expands the selected track volume in my case by about 5 clicks all in one touch. Use "All heights normal" to put all tracks back.
Cycle selection. Whatever you have selected is set to cycle and immediately starts. Used with Cycle zoom very powerful.
Fit Song.
Start. Goes to beginning and rolls immediately.
Direct Input was a tricky one. Had to use mouse movement.
Expand and Shrink both jump 4 clicks on each press. These are amazing, get you around quickly.
All my mixer buttons were the most difficult and if I am honest are still ongoing. Lots of help from tech support on these . Whats needed is sleep,sleep,sleep.
Object selection scrolls through the 3 types, each click selects the next one.
All others are self explanatory.
I am quite happy to share these but of course the exact number of jumps presses etc will need tailoring to suit your requirements.
Attached is a shot of my DTouch setup.
Ones I use all the time are :-
Roll & Record. This switches in metronome, activates punch in and punch out, activates pre roll, turns off cycle and immediately starts rolling. That's six buttons into one.
Bounce. use all the time, really quick once you are used to its position.
Show track volume. Opens and expands the selected track volume in my case by about 5 clicks all in one touch. Use "All heights normal" to put all tracks back.
Cycle selection. Whatever you have selected is set to cycle and immediately starts. Used with Cycle zoom very powerful.
Fit Song.
Start. Goes to beginning and rolls immediately.
Direct Input was a tricky one. Had to use mouse movement.
Expand and Shrink both jump 4 clicks on each press. These are amazing, get you around quickly.
All my mixer buttons were the most difficult and if I am honest are still ongoing. Lots of help from tech support on these . Whats needed is sleep,sleep,sleep.
Object selection scrolls through the 3 types, each click selects the next one.
All others are self explanatory.
I am quite happy to share these but of course the exact number of jumps presses etc will need tailoring to suit your requirements.
