DTouch 1.2.0 Update and Sends Volume Control Section

[rcprod]

Hello,

I was making good use of the sends volume controls section of DTouch for Cubase. (Where you could select send 3 for example and then control the send 3 volumes using each channel's fader.)

Is this section still available? I do not see it in the new 1.2.0 version of DTouch.

Thanks.

[Home Studio 87]

look at the "VOL" button, but if you want you can paste the DTouh "factory" command where you want.... look at the manual...

[DT_bettinzana]

Hello,

I was making good use of the sends volume controls section of DTouch for Cubase. (Where you could select send 3 for example and then control the send 3 volumes using each channel's fader.)

Is this section still available? I do not see it in the new 1.2.0 version of DTouch.

Thanks.

Check Page 64 of the User Guide (DTouch for Cubase V1.2.0 Revision 1): "Fader Control Mode Toolbar Panel"

[rcprod]

I did look over the manual quickly to check out new features/changes.....not a lot of spare time so did not go into it in detail.

Thanks, I will check out the page in the manual that you have pointed out. Cheers.